Battery Installation - MiDRONE ADVENTURE Benutzerhandbuch

5. Never leave small parts of drone to reach of children to avoid the risk of suffocation.
CHARGING AND USE OF THE LI-PO BATTERY
1. Check that the battery is in perfect condition before charging. If the battery appears damaged you
do not charge it to avoid damage or injuries.
2. Always use the original charger to recharge the battery. Using a non-matching charger could cause
irreversible damage to the battery and cause an accident.
3. When charging, if the charge connector is overheating, this means an excessive load and this can
cause permanent damage to the battery. Please stop charging immediately if this happens.
4. Do not leave the battery unattended while charging and do not leave load near flammable material
or in a vehicle.
5. When the drone has just finished flight, the battery temperature is higher, it is preferable to wait
for 30 minutes, and charge the lithium battery when cooled, otherwise it may damage the battery .
6. Do not short-circuit the battery polarity when connecting the charger.
7. Do not expose the battery to excessive heat, never throw it into the fire to avoid any risk of
explosion.
8. Do not dispose of the battery in domestic waste but bring it to a collection point for recycling,
please check with your local authorities about it.
DESCRIPTION OF THE REMOTE CONTROL
The supplied remote lets you control the drone up to a maximum distance of 70 meters.
REMARKS :
1. We recommend that you familiarize yourself with the buttons of the remote before you start using
the drone.

BATTERY INSTALLATION

1. Install batteries in the remote control
The operation of the remote requires 4 AA batteries (not included).
Observe the battery polarity when inserting in the compartment at the
back of the remote.
Remove the batteries from remote control for a long period of non-
use to avoid discharge and leakage.