Carat MICROCOUP 180 ALUMINIUM Bedienungsanleitung Seite 4

Angular cuts
Slide the mitre guide into place on the rip guide.
Slacken the thumb screw and set the required angle of cut.
Re-tighten the knob and position the tile within the jaws of the
mitre guide.
Switch on the machine and while holding the tile firmly in
position, push the mitre guide steadily along the rip guide,
feeding the tile through the cutting wheel. When the cut is
complete, switch off the machine.
Mitre cuts
For mitre cuts, raise the cutting table to the required angle (15,
30 or 45 degrees)
Locate the appropriate lugs into the slots provided on the
inside edge of the reservoir.
Place the tile against the angled table top.
Switch on the machine and feed the tile through the cutting
wheel. When the cut is complete, switch off the machine.
4