Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Adjusting the Height of
the Display
The stand and the display section of the PCS-TL30 are
joined by fastening screws. There are three sets of screw
holes, spaced 25 mm apart. In the factory default
condition, the display is fixed in the lowest position. By
choosing a different set of screw holes, you can change the
height of the display.
1
Remove the rear cover of the unit.
For information on how to do this, see page 26.
2
Remove the 4 screws using a coin or a similar object,
lift up the stand, and insert the positioning pin in the
hole for the new stand position.
Note
Before changing the height of the display as described
above, be sure to turn the power off. Place the display
face down on a soft cloth or similar.
Positioning pin
3
Tighten the 4 screws using a coin or a similar object to
secure the stand.
4
Attach the rear cover again.
For Best Performance
Operating or storage location
Avoid operating or storing the system in the following
locations:
• Extremely hot or cold places
• Humid or dusty places
• Places exposed to strong vibration
• Close to sources of strong magnetism
• Close to sources of powerful electromagnetic radiation,
such as radio or TV transmitters
• Places with high interference
LCD screen
• Do not expose the LCD screen surface to the sun. Doing
so may damage the screen surface.
• Do not push or scratch the LCD screen, or place objects
on top of the system. The image may become uneven or
the LCD panel may be damaged.
• If the system is used in a cold place, a smear may occur
in the picture or the picture may become dark. This does
not indicate a failure. These phenomena improve as the
temperature rises.
• Ghosting may occur when still pictures are displayed
continuously. It may disappear after a few moments.
• The screen and cabinet get warm when the system is in
use. This is not a malfunction.
Adjusting the Height of the Display / For Best Performance
31
Werbung
Kapitel
Inhaltsverzeichnis
