How To Use - FATMAN iTUBE carbon edition Bedienungsanleitung

how to use

CONNECTIONS
• Before attempting to make any connections to
or from the iTube firstly ensure that the iTube
and all connecting devices are switched OFF .
• When making connections to other devices
from the iTube, take the time to ensure that
they are correct . For instance, (L) Left to (L) left,
and (R) right to (R) right .
• Make sure connecting pins on wires are clean
and dust free and that all connectors are
inserted into the iTube fully and correctly .
• Always turn both the power switches to the
OFF position on the units when connecting or
disconnecting the iTube tube amp or the power
supply .
POwER
• Do not switch on the iTube or mains supply
until after you have connected the AC power
adaptor between them . It is recommended
that you disconnect the power supply from the
mains when the unit is in a protracted period
of non-use (when on holiday / travelling for
instance) .
Carbon EDITIon
8
SPEAkERS
• When connecting speakers, ensure they have an
impedance of between 4 & 8 ohms .
• Connect the speakers to the terminals using
either the supplied speaker cable (banana plug)
or high quality, bare(stripped) speaker wire .
(Please note that if your speaker wires are not
connected properly you may hear no sound, or
if polarities are reversed, you will hear oddities
in the signal path with an unnatural loss of bass
frequencies .
• When using bare speaker wires, fit at least
1 . 6 mm of insulation inside the speaker terminals
so that no bare wire is visible .
• Make sure the wire holders are firmly screwed in
to prevent wires from becoming loose . If wires
touch each other, the speakers and/or iTube
could be damaged .