En - Colad Spray Bottle - Colad 9705 Gebrauchsanleitung

EN - COLAD SPRAY BOTTLE

Congratulations on the acquisition of your new Colad Spray Bottle. Please read the operating instructions
carefully before using the device, and keep them in a safe place. If the device is passed on to a third party, it is
imperative that these instructions also be passed on with it.
Preparation:
Check before use that all parts are undamaged and working correctly. Unscrew the pump from the tank. Fill the
canister with liquid up to the "max" level. Screw the pump head on and tighten it so that the canister is sealed
and airtight (if it is not, it will be impossible for pressure to build up).
Usage:
Pump air into the tank using the piston (around 20 to 30 pump movements). Important: It is not possible to
generate more pressure in the tank than specified. The sprayers are fitted with an automatic relief valve. Press
the spray button to spray. By turning the spray nut, you can set the desired spray pattern (mist ↔ jet). If liquid
continues to drip out of the nozzle when releasing the spray button, there is still air in the sprayer. Spray
upwards at an incline for around two to three seconds to enable the air to escape.
After usage:
Once you have finished spraying, unscrew the spray head slowly to allow the pressure to escape. Do not pour
residues into drains; instead, dispose of them in accordance with the instructions of the manufacturer of the
liquid. Then clean the pump by using it to spray clean water or a suitable cleaning agent.
Safety:
• Never leave the tank in a pressurized state for long periods of time.
• Do not expose the Compressed Air Sprayer to direct sunlight.
• Do not fill any hot liquids exceeding 30° Celsius.
• Note the safety data sheet of the liquid's manufacturer.
• Information on the resistance properties of the plastic and seals of the Compressed Air Sprayer can be found
under www.emm.com.
• Never aim the sprayer at people or animals.
• The manufacturer is not liable for damage caused by incorrect usage or unauthorized modifications of the
device.
Maintenance and care:
• Oil the pump piston from time to time with a drop of maintenance oil.
• Check that the nozzle and sieve at the end of the hose is free of deposits. Use compressed air to clean the
nozzle or sieve if it is blocked.
• If a part is visibly damaged or worn, replace it. Only use original parts.
• Spare parts and sets of seals can be obtained from your supplier or dealer.
Safety advice
When spraying various liquids, we always advise to wear safety goggles to protect your eyes from coming into
contact with these liquids. To protect yourself in the best way, always read the Material Safety Data Sheets
from the liquids you are going to spray. Follow their advised recommendation according to the necessary
Personal Protective Equipment (PPE) in relation with the used liquid.
6