Power Connection; Appliance Description - Landig PRO-STAR Bedienungsanleitung

3. Keep the original packaging for the
duration of the appliance's warranty
or guarantee period so that the ap-
pliance can be packaged properly for
shipping in the event of a warranty
claim. Shipping damage voids the
guarantee or warranty.
4. Check the contents, including in the
pusher, for completeness and visible
damage. Do not operate a damaged
appliance.

Power connection

The following regulations for the electrical
supply must be observed to ensure safe
and trouble-free operation of the appli-
ance:
► Be certain that the appliance can be
connected to a properly installed pro-
tective conductor electrical system. Op-
eration using a socket without an earth
conductor is not permitted. If in doubt,
have the house mains network inspect-
ed by an electrician. The manufacturer
assumes no responsibility for damage
resulting from the absence or interrup-
tion of a protective earth conductor.
► Before connecting the appliance, com-
pare the electrical data (voltage and
frequency) on the type plate with that
of your electrical mains network. These
data must match to avoid damage to
the appliance. If in doubt, ask your elec-
trical appliance retailer.
► Be certain that the socket is protected
by at least a 16 A fuse.
► Be certain that the power supply cord is
not damaged. Route the power supply
cord in such a way that it poses no risk
of stumbling. The power supply cord
must not be routed over sharp edges,
be pulled taut kinked, crushed or knot-
ted. The power supply cord must not
come into contact with hot surfaces.
14
Before first use
1. Clean the appliance and the acces-
sories, including parts in the pusher,
as described in the chapter Cleaning
and care (page 18).
NOTE
► When using for the first time, it is
possible that production-related
additives such as grease could
cause slight odour or smoke. This is
completely normal! Ensure sufficient
ventilation.

Appliance description

(For illustrations, see the fold out page
at the left)
1 Tamper with cover
2 Hopper
3 Holding fixture for attachment body
4 Catch for attachment body
5 Motor block
6 On/off switch
7 Reversing button
8 Indicator lamp
9 Sausage filling tube
10 Spout
11 Shaper
12 Sausage filling screen
13 Spritz biscuit attachment
14 Slider
15 Fine screen (Ø 3 mm)
16 Medium screen (Ø 4.5 mm)
17 Coarse screen (Ø 8 mm)
18 Ring nut
19 mincing knife
20 Screw
21 Attachment body
22 Drive sprocket
23 User manual (not shown)
EN