Using The Drive - Panasonic CF-VCW282 Bedienungsanleitung

Using the Drive

Installing/Removing a Drive
Refer to the Reference Manual included with your computer on how to install/remove the drive.
CAUTION
Be sure to turn the computer off before installing/removing the drive.
Preparations
Windows 98
E
Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] - [CDROM] - [MATSHITA UJDA***] - [Properties] - [Settings]. Make the set-
tings if they have not yet been made.
• Add a check mark for [DMA].
• Set both [Start drive letter] and [End drive letter] in [Reserved drive letters] to [L:].
Windows 2000
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Settings] - [Control
Panel] - [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] - [Sec-
ondary IDE Channel] - [Advanced Settings] - [Device 0]. Perform this setting if it has not
yet been made.
Windows XP
Confirm that [Transfer Mode] is set to [DMA if available] in [start] - [Control Panel] -
[Performance and Maintenance] - [System] - [Hardware] - [Device Manager] - [IDE ATA/
ATAPI controllers] - [Secondary IDE Channel] - [Advanced Settings] - [Device 0]. Perform
this setting if it has not yet been made.
6