Jamie Oliver PRO 6 Bedienungsanleitung Seite 16

141215
MANUAL IGNITION
If necessary this barbecue can be lit manually.
Main Burners
1. Open the lid before lighting.
2. Light a 90mm barbecue match and hold close to the burner located on the far left of the barbecue.
3. Turn the left burner control knob to the full rate position. The burner will light from the match.
4. Once the left burner is lit, the burner next to it can be turned on.
5. Light remain burners from left to right.
6. When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-clockwise to any
position between the full and low rate position.
Side burner (If applicable):
1. Open the lid before lighting.
2. If igniter fails to spark, use a match to light burner.
After use, close the gas supply by either turning OFF the switch on the regulator or turning OFF the cylinder valve.
In the event of light back whilst the barbecue is in use. Turn all the controls, cylinder valve and regulator switch to the 'O'
position. Wait 5 minutes before attempting to relight the barbecue. If the problem persists after relighting, consult your gas
dealer, or the store where you purchased the barbecue, or a qualified gas engineer for assistance or repair. Never try to
fix the problem yourself as this could result in serious injury and/or property damage.
The reccomended pot size to use on the side burner should be around 180~220mm.
Clean the barbecue of excess fat, before storage, with a damp cloth using a mild detergent solution as the cleaning agent.
Store the barbecue in a clean dry environment.
Do not store your gas cylinder indoors. Store in a well ventilated area away from direct sunlight
CONNECTING THE GAS CYLINDER TO THE BARBECUE
This barbecue is only suitable for use with low-pressure butane or propane gas and fitted with the appropriate low-
pressure regulator via a flexible hose. The hose should be secured to the regulator and the barbecue with hose clips/
nut. This barbecue is set to operate a 28 mbar regulator with butane gas or a 37mbar regulator with propane gas or a
regulator with butane/propane mixture at 37mbar or a regulator with butane/propane mixture at 50mbar or a regulator
with butane/propane mixture at 30mbar. Use a suitable regulator certified to BSEN 16129. Please consult your LPG
dealer for information regarding a suitable regulator for the gas cylinder.
BEFORE USE PLEASE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts water. Ensure the
control valve is off.
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are secure then turn ON
the gas.
Brush the soapy solution on to the hose and all joints. If bubbles appear you have a leak, which must be fixed before use.
Retest after fixing the fault. Turn off the gas at the cylinder after testing.
If the detected leak can not be fixed, do not attempt to fix the leak but consult your gas dealer.
9