Wireless Lan - NEC DS1-MP10RX1 Wichtige Informationen

INFORMATION
Settings are displayed for connecting this product to a wireless or wired LAN.

WIRELESS LAN

Configure the settings for wirelessly connecting this product to the network.
NOTE: wireless LAN is disabled while a wired network adaptor is in use.
Item
PROFILE • SIMPLE ACCESS POINT
• INTELLIGENT CONNECTION
• INFRASTRUCTURE
DHCP/ Set these when [INFRASTRUCTURE] is selected for
IP ADDRESS/ [PROFILE].
SUBNET MASK /
GATEWAY
DETAIL SETTINGS The configuration items are differed in each profile
option. Refer to the following table.
RECONNECT Attempt connecting to the network. Select this after
changing the configuration.
DETAIL SETTINGS (SIMPLE ACCESS POINT)
Item
CHANNEL Select a wireless channel.
When set to [AUTO], this product reconnects to the
network by searching nearby access point channels
and selecting the least used one from among chan-
nels 1, 6, and 11.
SSID Set the SSID.
Description
Set this product as a simple access point for con-
necting to a computer or a smart phone.
Easily connect to a computer or a smart phone
utilizing the application software, MultiPresenter,
installed on them.
Connect this product to an access point.
Description
• The default factory setting is [INTEL-
LIGENT CONNECTION].
• If either [SIMPLE ACCESS POINT] or
[INTELLIGENT CONNECTION] has been
set up, the IP address for this product is
"192.168.120.1" and the subnet mask
is "255.255.255.0".
Note: Number of device that can be simul-
taneously connected under SIMPLE ACCESS
POINT or INTELLIGENT CONNECTION is up to
twelve units.
Recommendable number of device for si-
multaneous connection is up to eight units
for normal operation.
• The default factory setting is [AUTO].
• The default factory setting is produc-
tion serial number.
• Consists of 1 to 32 alphanumeric char-
acters.
ENG-10
Remarks
Remarks