Using The Various Functions - Denon TU-235RD Bedienungsanleitung

ENGLISH

Using the Various Functions

1. Using the auto preset memory function
This function automatically stores the FM stations which can
be received in the area in which the set is being used in the
preset memory. Use this function so that the RDS functions
can be used more effectively. Also note that the channel
memories can be changed at will even after the preset
stations have been stored with this function.
Operation
1. Connect the FM antenna and set it so that FM stations can
be received.
2. Press the ON/STANDBY button to turn on the power while
holding in the MEMORY button.
3. Searching begins automatically, and stations are stored in
the preset memory in order, beginning from channel A1.
(The operation automatically stops once 40 stations have
been set in the memory.)
2. Storing new stations at the preset channels
The reception frequency, RDS service information, Tuning
mode and input characters can be stored at the different
channel memories. When this operation is performed, the
station already stored in that channel memory using the auto
preset memory function is cleared.
Operation
1. Press the MEMORY button. (The MEMO indicator flashes.)
2. Use the SHIFT/PTY button to select the block, A to E.
3. Use buttons 1 to 8 to select the channel at which the
station is to be stored.
3. Recalling preset channels
Use the following operation to recall preset channels:
Operation
1. Use the SHIFT/PTY button to select the block, A to E.
2. Use buttons 1 to 8 to select the channel at which to store
the station.
4. Inputting characters
Any characters can be input (up to 8 characters).
The input characters can be stored at the preset channels.
Operation
1. Press the SEARCH/CHARACTER button four times.
(The cursor flashes at the first place.)
Flashes
2. Use the TUNING/PRESET control to select the character
for the first place.
(The selected character flashes.)
Flashes
10
3. Press the SHIFT/PTY button to move the cursor to the next
place.
(The cursor flashes at the second place.)
Flashes
4. Repeat steps 2 and 3 above to input up to 8 characters.
Flashes
5. The characters are set five seconds after the input
procedure is finished. The input characters can be stored in
the memory.
To keep the input characters, be sure to store them in a
channel memory.
6. Clearing characters
1. Recall the character you want to clear.
2. Press the SEARCH/CHARACTER button 4 times until
the character at the first place flashes.
3. Then press the SHIFT/PTY button for at least 2
seconds. The current character will then be cleared.
Using the RDS Functions (for FM only)
1. RDS Search
Use this to automatically search and stop at stations offering
RDS services.
Operation
1. Press the SEARCH/CHARACTER button once.
2. Turn the TUNING/PRESET control clockwise or
counterclockwise.
(Searching begins.)
Flashes
RDS
3. Searching starts again when the TUNING/PRESET control
is turned clockwise or counterclockwise while the RDS
indicator is flashing.
Flashes
RDS
4. If no other RDS station is found when all the frequencies
are searched, "NO RDS" is displayed.
Flashes