Installing The Cooker Hood - Luisi Air FOGO Bedienungsanleitung Mit Montageanweisungen

INSTALLING THE
COOKER HOOD
1. Before carrying out the appliance installation,
please check that all components are not da-
maged, in such a case contact your retailer
and do not carry out any installation operation.
Remove safety packing before the installa-
tion of the downdraft. Furthermore, please
read carefully all of the following installation
instructions.
● Use an air exhausting pipe whose maximum
length does not exceed 5 meters.
● Limit the number of elbows in the piping,
since each elbow reduces the air capacity of
1 linear meter. (Ex.: if you use no. 2 x 90° el-
bows, the length of piping should not exceed
3 meters).
● Avoid abrupt direction changes.
● Use a 150 mm. constant diameter pipe for
the whole length.
● Use piping approved by standards in force.
The manufacturer shall not be deemed re-
sponsible for air capacity or noise problems
caused by failure to comply with the above
instructions and no warranty on the product
shall be provided.
2. Before making the hole, check that there are
no structural or other parts inside the cabinet,
where the appliance is to be placed, which
could hinder a proper installation.
Check that the dimensions of the Downdraft
and the ones of the cook top are compatible
with the cabinet so that the installation can be
carried out properly.
3. Make a rectangular opening, 850x115 mm in
size, in the back of the cook top for the 90 cm
model.
4. Put the Downdraft in the opening, inserting it
from above as shown in (Fig. 1).
FOGO
EN
5. Fix the downdraft inside the cabinet, using the
special fixing brackets supplied with the pro-
duct (Fig. 2).
Insert the brackets in the lower side of the
downdraft (Fig. 2), in such a way that there
is a 2 mm distance between the lower side of
bracket and the bottom of the cabinet (Fig. 2).
This distance will allow the traction to be po-
sitioned downwards of the product, at the mo-
ment of fixing, in order to have the stainless
steel trim perfectly adhering with the work
surface.
Before inserting the screws, please make sure
that the appliance is perfectly perpendicular
with the work surface.
6. In the version of the Downdraft equipped with
internal motor, install the power unit orienting
the air outlet to the desired position, either
downwards or upwards (Fig. 3).
The motor can be installed either on the front
or rear side of the downdraft After having in-
stalled the motor, connect the air ducts.
7. For versions with external motor, place the
suctioning unit (external motor) in a suitable
area and fit the exhaust air flue as illustrated.
Then fit the air outlet ducts between the ex-
ternal motor and the downdraft. Select an air
outlet from the five possibilities (Fig. 4) and fit
the union supplied with the appliance.
8. Place the metal box with the electronic com-
ponents in an easily reachable area for even-
tual technical assistance operations. (Fig. 5),
connecting the three connectors (9 pole con-
nector for the actuator control and the safety
control, 4 pole connector for neon lamp turn
on and push-button connector) (Fig. 6).
9. For motors, connect the motor unit cable to
the relevant connector on the elec-trical com-
ponents box. (fig. 7)
10. Power the cookerhood.
11.
Let the suction carriage rise, as described
in Chapter "How does the downdraft works".
When the downdraft is fully arisen, unscrew
and remove the safety locks (see pic. 8). In-
stall accurately the metal filters in their loca-
tion (see pic. 9).
17