ABB PowerValue 11 RT 1-3 kVA B Kurzanleitung Seite 15

WATER CONDENSING MAY OCCUR IF THE UPS IS UNPACKED IN A VERY
LOW TEMPERATURE. IN THIS CASE IT IS NECESSARY TO WAIT UNTIL THE
UPS IS FULLY DRIED INSIDE OUT BEFORE PROCEEDING INSTALLATION
AND USE TO AVOID HAZARDS AND ELECTRIC SHOCK, WAIT UNTIL THE
WARNING
UPS IS FULLY DRY BOTH INSIDE AND OUTSIDE BEFORE INSTALLING.
AN INTEGRAL SINGLE EMERGENCY SWITCHING DEVICE THAT PREVENTS
FURTHER SUPPLY TO THE LOAD BY THE UPS IN ANY MODE OF
OPERATION MUST BE PROVIDED IN THE BUILDING WIRING INSTALLATION.
CAUTION
DO NOT CONNECT EQUIPMENT THAT COULD OVERLOAD THE UPS
SYSTEM (FOR EXAMPLE LASER PRINTERS).
CAUTION
Operation
DO NOT OPERATE IN CASE OF PRESENCE OF WATER OR MOISTURE.
CAUTION
DO NOT DISCONNECT THE MAINS CABLE FROM THE UPS OR THE
BUILDING WIRING SOCKET DURING OPERATION AS THIS REMOVES THE
GROUND FROM THE UPS AND ALL CONNECTED LOADS.
CAUTION
SWITCH OFF THE CONNECTED LOADS BEFORE TURNING ON THE UPS.
THEN SWITCH ON THE LOADS ONE BY ONE AFTER THE UPS IS TURNED
ON. SWITCH OFF ALL OF THE CONNECTED LOADS BEFORE TURNING OFF
THE UPS.
CAUTION
REPLACE FUSES ONLY BY DEVICES OF THE SAME TYPE AND OF THE
SAME AMPERAGE TO AVOID FIRE HAZARDS.
CAUTION
Quick guide | PowerValue 11 RT 1-3 kVA 13
1 e n