Heating; Kindling; Stoking Up Of The Fire With Wood - Firewood; Stoking Up Of The Fire With Wood - Operation - Saey ePure Aufstell- Und Bedienungsanleitung

12. Heating

Kindling

12.1
Set the air inlet to maximum for the lighting of the stove.
Through the filler door opening, spread out a broad layer of small kindling-wood on the floor of the
combustion chamber. Now lay the required quantity of firewood on top. Place a thin layer of firewood op top
of this, and then a bit of splintery wood.
Use about 3 matches to light all the wood. We suggest the following: one match at the back and two at the
front. This will ensure that everything ignites well.
You could also use 1-2 firelighters. Now add a small quantity of fuel. Close the door firmly after the fire has
been lit.
Stoking up of the fire with wood – Firewood
12.2
To ensure that the appliance rapidly reaches the desired temperature so that the release of harmful
substances is kept to a minimum, you must follow the following heating method after kindling the fire:
Place 2-3 small pieces of wood, max. 2 kg in size, in the appliance in two layers; set the air inlet to
maximum position.
The setting of the combustion air inlet must be changed from maximum to half when the fuel is burning well
(± 10 min).
Stoking up of the fire with wood – Operation
12.3
Wood burns for a long time and emits a lot of gas; it must be burnt rapidly and with a constant supply of
oxygen. To prevent possible detrimental effects due to prolonged periods of reduced air supply, it is
advisable to let the Saey EPure burn at its maximum capacity for 15 minutes every day.
Possible detrimental effects:
•
Smouldering fire, condensation and tar deposits
•
Heavy soot deposits
•
Inconvenience caused by smoke (emission of harmful substances)
•
Risk of explosion
WOOD IS NOT SUITABLE FOR A SMALL FIRE OR ONE THAT BURNS FOR A LONG TIME!
However, it could take a while for the wood to burn up completely. This means that, by closing the air inlet
on the front , the set temperature is only reached once the wood is almost burnt up and the degassing
process – the large flames die down and the wood has been reduced to glowing embers – has been
completed!
In particular, you should avoid adding too much fuel, since this will result in excessive heat emission as well
as a high level of emission of combustion gases.
Stocking up the fire with wood – Removal of the ash
12.4
Correct stoking up of the fire with wood will ensure that the volume of ash is reduced to a minimum. Thus,
the remaining charcoal can also burn up in the glowing embers.

13. Spare parts

You can obtain spare parts from your dealer.
59