wilux STEAMY LIGHT Bedienungsanleitung Seite 12

Istruzioni Steamy Light 05-04-2004 09:10 Pagina 12
Cleaning of the heater
After each steam bath a cleaning cycle of the steam generator must be carried out, this
is fundamental for the duration of the heater.
Press the key @@ during 3 seconds to activate the cleaning cycle of the heater. The
lower led will start blinking and the cleaning cycle starts automatically. During the
cleaning cycle DO NOT INTERRUPT THE POWER that feeds the system, to avoid
stagnation of water in the steam generator until the next treatment.
The cleaning cycle has to be terminated before you can start a new steam bath
treatment.
Anti-calc cycle
After approximately 15 hours of functioning, the two leds will start blinking at the same
time, indicating the necessity to effect the anti-calc cycle. From now on the steam bath
functions cannot be operated anymore.
Fill the tank with two spoons of pure citric acid (remove the round cap with the symbol
@@ which you can find on the shelf), otherwise you cannot activate the anti-calc cycle.
Press the keys @@+@@ at the same time. The two leds will be blinking slowly together
to indicate that the anti-calc cycle is active. The anti-calc cycle consists in:
• Filling of the steam generator
• Steam bath cycle of 5 minutes
• Water outlet during 50 seconds
• Filling of the steam generator with fresh water
• Water outlet during 50 seconds
• Filling of the steam generator with fresh water
• Water outlet during 50 seconds
After the anti-calc cycle has been terminated, the steam bath functions can be operated
again.
Error marks
If the two leds blink alternatively there are two possible problems:
- The safety thermostat of the heater has been activated
- The heater has not been filled automatically with water
Contact your dealer or the service assistence Wilux to resolve the problem
12