Save These Instructions; Installation Record; Installation; Start Up And Operation - Waterco TC400 Bedienungsanleitung

SAVE THESE INSTRUCTIONS

~ INSTALLATION RECORD ~

Clean Filter Pressure Gauge Reading : ____________________________________________________
Filter Model : _________________________________________________________________
: _________________________________________________________________
Filter Serial
Date of Purchase : _________________________________________________________________
: _________________________________________________________________
Purchased from
Installed by : _________________________________________________________________
.: _________________________________________________________________
Installer Phone No
I pg 02

INSTALLATION

1. Check carton and filter components for damage. If anything is damaged, notify the carrier
immediately.
2. Wrap one to two turns of Teflon tape around the thread of the pressure gauge. Screw the
pressure gauge into the threaded hole on the tank.
3. Filtration equipment should be located as close to the pool/spa as possible. Locate the filter
on a flat concrete slab in a well ventilated area free from flooding. Ensure there is adequate
drainage.
4. Align the filter so the inlet and outlet are positioned as required.
Connect the filter inlet to the pump outlet.
5. Install electrical controls away from pool equipment for
access in case of emergency.
6. Allow sufficient clearance around and above the filter to
allow for removal of the top section of the tank.
7. To reduce pressure losses, use as few bends, elbows and
fittings as possible. Select the appropriate pipe grade as
specified by local regulations.
8. Use a minimum of 50mm (2 inch) UPVC piping or larger.
9. Piping should be independently supported to reduce
strain on the filter.
10. Do not use tools to tighten the half unions.
Hand-tighten only.

START UP AND OPERATION

Fulflo Cartridge Filter Start Up

The following steps should be carried out for the first run of a new season or after the filter has
been reassembled.
1. Ensure the pump is off. Fill the pump's hair and lint pot with water and replace the lid.
2. Loosen (do not remove) the air release valve on the top of the filter.
3. Turn the pump on to circulate water through the system. When a steady amount of water comes
out through the top of the air release valve, close the air release valve. All the air will have been
purged from inside the filter.

Normal Operation

If the pump loses its prime, you will need to follow the procedure set out for the filter start up.
Over time and depending on how much the pool collects debris, the dirt loading in the filter
increases, the pressure gauge reading will rise. When the value has risen 50kPa/7.25PSI above a
clean filter element reading, you will need to clean the filter. Refer to Maintenance.
I pg 03