Beautural Fabric Bedienungsanleitung Seite 4

Switch to Speed Level 1. To test the most suitable
EN
speed for your fabrics and avoid damaging the
DE
garment, it is recommended to use Speed Level 1
FR
first, then switch up to Speed Level 2.
ES
Shaving Off Fluff
JP
1. Put the garment on a flat surface, such as an
IT
ironing board. Make sure the surface has no
wrinkles. Otherwise, the garment may be
damaged.
2. Turn the spacer to the desired level or remove it
completely (see the "Removing/Attaching the
Spacer" section of this manual).
• "Thick" is for large bobbles and coarse textiles;
5mm-length distance from the cutting blades.
• "Thin" is for small lint/bobbles and fine textiles;
3mm-length distance from the cutting blades.
• Removing the spacer is only for very fine lint;
virtually no spacing to the cutting blades.
3. Push the On/Off/Speed Switch to the required
speed level.
4. Guide the shaver foil lightly over the material.
The fluff and bobbles will be shaved off and
collected in the fluff collector.
5. To turn off the shaver, push the On/Off/Speed
Switch back to Speed Level 0.
Note:
• Empty the fluff collector regularly. The fluff
collector should never be more than 3/4 full. An
04
overfilled fluff collector will slow the cutting blades
no matter the amount of battery power left.
Removing/Attaching the Spacer
• To remove the spacer, hold the shaver with one
hand, grab the spacer, put your thumb on the
edge of the spacer, pull the spacer forward, and
remove it.
• To attach the spacer, place it on the cutting head
and press it firmly. Make sure the two small tabs
on the spacer grip into the two recesses on the
shaver.
05
EN
DE
FR
ES
JP
IT