Cleaning And Maintance - Sharp Slow Juicer Bedienungsanleitung

for a few seconds. Switch off "O" and tun on (I) again.
- If reverse "R" don't work, turn off juicer "O", unplug and reassemble the juicier by
following "product assembly" instructions, plug in and turn on "I" the juicer.
7. Once juice container is full (the maximum capacity is 400ml) or work done, please
switch off the juicer "0" and empty both containers before continuing to use.
Note: The maximum time of operation should not exceed 15 minutes and it is
recommended to maintain minimum 30 minutes of rest time between continuous
two cycles.
Note: Do not insert too much food to extract per time. During operation, once the juice
container is full, you must stop the appliance and empty the residue container before
next cycle.
Note: During operation, if the interlock switch between the jar lid and the motor unit is
disconnected, the motor will stop to prevent from danger.

Cleaning and Maintance

1. In order to make easy the disassembly and cleaning of the appliance, run the juicer
without any load for around 30 seconds. If the jar lid is hard to detach, try to turn
on reverse "R" or pout some water into feeding tube to clean it.
2. Before cleaning, unplug the appliance and wait until it is cool down.
3. Reverse the assembly procedure to take the juicer apart.
Caution: DO NOT switch directly from "I" to "R" nor "R" to "I" at any time during
operation. If required, always switch off the juicer by switching to "O" position.
Once juicer stop working, select "I" or "R".
Note: The grinding head can be easily detached from juicing jar, if pushed the axis at the
bottom of the juicing jar (see Fig. 7)
4. Empty the residue container, and then clean the jar lid, grinding head, strainer, jar
and residue container under running water. When cleaning the strainer, only need
to brush the concave surface of the strainer under running water with the small
cleaning brush for several times, and then the whole strainer can be cleaned well.
EN-8