wilux DUOTRONIC PLUS Bedienungsanleitung Seite 17

Istruzioni Duotronic Plus 07-04-2004 08:11 Pagina 17
The PLUS System will be activated automatically now, washing the tubes during 2 minutes
with clean water to remove any residual of disinfection liquid. After 5 minutes the blower
will be activated to blow air into the circuit for 1 minute at maximum speed to dry out all
the residual water in the air jets and air system pipes. A long buzzer sound indicates the
end of the cleaning cycle.
PLUS-System
The PLUS-System washes the tubes automatically with clean water to remove any residual
of disinfection liquid after the cleaning cycle. The PLUS system can only function with an
extra water connection (see photo page 14).
Regulation temperature
In case the water temperature visualised on the display is not exact you can change this
value. Disconnect the system from the tension 220V, then press the key SELECTION
TEMPERATURE @@ and maintaining it pressed connect again the system. After 5
seconds the display will visualize the measured temperature. You can vary this value
with the key @@, with a maximum of 5 degrees. To terminate and memorize press again
key @@.
Regulation clock
The hour is visualised only when the system is under tension. If the system remains without
tension, the clock will maintain its function through a battery (duration 10 years).
The regulation of the hour can be carried out by pressing and maintaining pressed for 5
seconds the key SELECTION DURATION PROGRAM @@. The indication of the hours will
be blinking. Change the value with the key @@ and then press key @@. The indication of
the minutes will be blinking now, change the value with the key @@ and then press key @@
to confirm.
VISUAL PRESENTATION SYSTEM
17