wilux DUOTRONIC PLUS Bedienungsanleitung Seite 15

Istruzioni Duotronic Plus 07-04-2004 08:11 Pagina 15
Each active function is signalled by the illumination of a red led.
Introduction
If the system is under tension the led INDICATION PRESENCE OF TENSION
illuminated. All the keys are active. If you press a key of which the function is not available,
the display will visualize 4 blinking hyphens for approximately 3 seconds.
Fill the bathtub with water. You can check the water temperature on the display by
pressing the key SELECTION TEMPERATURE @@. The ideal water temperature is
37/38°C; to achieve this temperature add cold and warm water by the taps. When the
water level will be sufficient, the led indicating this level
more. Now it is possible to activate any function.
How does the waterpump function
The two hydromassage systems water and air can function separately or in combination.
The memorised duration is valid for the first chosen system. In case of combined
functioning it is possible to exclude the blower without stopping the hydromassage.
The keyboard has 3 different programs in the memory regarding the duration of the
hydromassage: 10 – 20 or 30 minutes. To choose the one you desire press the key
SELECTION TIME PROGRAMM
hydromassage will function for the chosen duration.
When the pump starts, the airflow towards the jets is at the maximum, to stop the airflow,
press the key AIR REGULATION JETS @@. To return to the maximum repress the same key.
It is possible to select the function pulsating massage by pressing the key AIR REGULATION
JETS
LED AND FUNCTIONS
waterpump on/off
air regulation jets
heater on/off
selection duration program
indication water level
indication presence of tension
blower on/off
air regulation blower
selection temperature
light on/off
cleaning cycle
@@ for 3 seconds, to return to the previous situation press the same key.
@@@
@@ and start the pump by pressing @@. The
15
@@ is
will not be illuminated any