Johnson Fluent Ceramic Bedienungsanleitung Seite 9

COMPONENTS
) Water tank
B) Ceramic plate
C) Spray button
D) Water tank cover
E)
Steam regulation knob
F)
Pushbutton for "spray"
G) Pushbutton for steam
H) Thermostat
I)
Light indicator
L)
Cable spherical joint
M) "Self-cleaning" button
N) Stainless steel upper border heated
INSTRUCTIONS FOR USE
In order to avoid overload to the electric
network, avoid using on the same circuit
and at the same time other appliances
with high voltage
SETTING THE TEMPER TURE
Look for the iron on the garment label with the
indication in dots for the right temperature to
set on the thermostat of your appliance. Iron
the garment following this indication.
If the garment does not have a label follow
following table:
• Nylon and acetate
•• Wool, silk and mixed fabrics
••• Cotton, flax (steam)
These indications concern the fabric of the
garment and not the eventual applications in
other materials as embroidery, drawings;
etc... the fabrics with applied finishing
(embossed drawings, embroideries) should
be ironed at medium temperature
In case the fabric is composed of various
fibres always choose the temperature
suitable for the fibre that requests the lowest
temperature.
IRONING WITHOUT STE M
1) Insert the plug in a suitable wall socket
2) With E exclude the emission of steam
3) Turn the H thermostat until the indication
of the chosen temperature matches with
the reference triangle that is on the tank.
The pilot light I will turn off when the reque-
sted temperature is reached.
4) Now you can iron remembering to check
the temperature requested as by the type
of fabric.
W TER T NK FILLING
5) With plug disconnected
6) Important: During filling of the water tank,
E must be in the position that excludes the
emission of steam.
7) Open the lid D.
8) Fill tank
with water (without additives).
Position the iron in a vertical position to make
sure the amount of water does not exceed the
maximum level.
STE M-IRONING
9) With the water tank already filled
(as indicated in preceding paragraph) insert
the plug in a suitable wall socket.
10) Regulate the H thermostat at the maxi-
mum temperature (indicated with (•••)
Wait until the pilot light turns off, this indi-
cates that the requested temperature has
been reached. The steam ironing is possible
only with high temperature, in the contrary;
you could have water lose from the plate.
11) With E select the quantity of steam (min.
or max.)
12) Now you can iron with steam until the
water is finished. When you have finished
ironing remove the plug (15) and empty the
tank (16) before storing the iron.
SPR YING
13) You can use the function spray with steam
or dry ironing, to activate it push the button F
(at the beginning you may have to press a
few times).
SHOT OF STE M
The steam shot function helps remove stub-
born creases.
14) With the thermostat on "••• " and the
luminous indicator off press the push-button G
and you will obtain steam (at the beginning it
may be necessary to press a few times).
9