Seav Radiocomando Smart Betriebsanleitung Seite 3

English
P4
P3
P2
P1
HOOD TIMER
P1: TIMER function activation/deactivation (5 minutes
for EU, 10 minutes for USA).
hood sensor: AUTOMATIC function activation/
deactivation.
P2: Motor off/motor speed decrease.
P3: Motor on/motor speed increase.
P4: Lights on/off.
P1+P4: Filter alarm reset.
HOOD LIFT
P1: Lift opening/closing.
P2: Motor off/motor speed decrease.
P3: Motor on/motor speed increase.
P4: Lights on/off.
P1+P4: Filter alarm reset.
P3+P4: OFF-MODE
Only for compatible models is possible to have the
OFF-MODE function that, independently from the
working mode, shuts motor and lights OFF at the
same time.
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERY TO THE INSTRUCTION.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
• This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Battery disposal
When the batteries need to be replaced, dispose of them only and exclusively in the numerous readily available
special waste bins, especially in shops selling electronic consumer goods. Observance of the regulations on
differentiated waste collection, in particular, proper disposal of used batteries, contributes to preventing possible
negative effects on the environment and health.
As soon as the button is
pressed, the circular crown
lights up for 1 second.
FCC ID: QUS-BESMARTNEW
IC: 11613A-BESMARTNEW
LINKING procedure
- To associate the remote control with the hood, you
can activate a LINKING procedure. Once the
procedure has terminated, the remote control
functions only and exclusively with the associated
hood.
- This procedure is useful if there are two or more
products that can be controlled by means of remote
control, for example, in apartments with adjacent
kitchens, showrooms, fairs, etc.
1 - Turn off the hood motor and the lights
2 - Press P1 for 3 seconds: the circular crown will
light up
3 - Confirm the link to the hood within 3 seconds by
pressing the button indicated on the next page.
Hood (1) / Lift (1) = Confirm P1
Hood (2) = Confirm P5
Hood (3) = Confirm P2
Hood (4) = Confirm P1
Lift (2) = Confirm P2