Set Chainring's Shift Timing - CAMPAGNOLO ErgoBrain Bedienungsanleitung

8. Set chainring's shift timing.

Danger!
This operation must be performed as you are riding the bicycle.
Note: If this is not a "first time" setting, and if you have not changed the
Install the main unit onto your bicycle and ride it.
First, shift into the inner chainring and the fifth sprocket.
Important: In this procedure, Ergopower shifting should be done
Shift from the inner chainring to the middle. Push S/S button. Shift from
the middle to the outer. Push S/S button again. Repeat this operation
with the shifting down from outer - middle - inner. When shift timing
setting is completed, the screen moves to the measuring screen.
Note: If "Error" display appears on the screen, the main unit is not in-
8123 8 85.4977866.2831847.0685820.7853988
To measuring screen
- 7
UK
Therefore, in order to minimize the potential of an accident,
this operation must be performed in a wide, open space which
is free from traffic or other obstacles.
chainrings or adjusted the tension of the front derailleur cable
since last time, you can skip this procedure. To skip this, just
push S/S button. This completes all the setting and the screen
moves to measuring mode.
slowly and steadily. S/S button should be pushed when
the chain has securely shifted to the next chainring.
stalled firmly onto the bracket, or there may be a problem with
the sensor of the Ergopower lever.
Shift chainring
S/S
Important:
In this page, the operation of S/S but-
ton should be done with the lever's
button.
Start with
the inner chainring
and the fifth sprocket.
F-1/R-5
Memorize timing
at each shift
S/S
F2 - 3 - 2 - 1
Continue shifting and
push S/S button
each time.