Leadtek WinFast VP200 Schnellstartanleitung Seite 8

Audio:
The Portal uses the Realtek High-Definition Audio Codec. Windows Vista natively
contains an HD Audio driver for this Codec. For other operating systems, including
Windows XP, please install the High-Definition Audio Codec driver from
www.realtek.com to use PCoIP System's full audio capabilities.
IP Address:
The Portal and Host are set to DHCP client mode by default. Normally, the IP address
of the Portal and Host are assigned by the DHCP server on your IP network. If your IP
network does not have a DHCP server, the Portal and Host Card will fall back to a static
IP address mode after a timeout period of approximately 2 minutes. In the fall back
static IP address mode, you can access the Portal and Host web interface to disable
DHCP client mode and assign a static IP address. The Portal's fall back IP address is
192.168.1.50 and Host's fall back IP address is 192.168.1.100.
Portal Buttons:
The Portal's Power Button (2) is a multi-function button.
A short push (< 4 seconds) power on the Portal.
!
A long push (> 4 seconds) power off the Portal.
!
When the Portal is connected in a session, a short push will disconnect it from the
!
Host.
The Portal's Remote PC Power Button (3) is used to remotely control the host PC's
front-panel power switch. To enable this function, the PCoIP Host Card Power Button
Cable must be connected as described in Remote Power Management.
A short push (< 4 seconds) set the host PC to sleep.
!
A long push (> 4 seconds) shut down the host PC.
!
Host Card Factory Default Reset:
To reset the Host Card to its factory default configuration:
1. Power off the Host PC and disconnect it from AC power.
2. Insert a jumper to the Factory Default Reset header JP1 (20).
3. Power on the Host Card and wait until the heartbeat LED (19) blinks.
4. Power off the Host PC.
5. Remove the Factory Default Reset jumper JP1.
5