Herunterladen Inhalt Inhalt Diese Seite drucken

Setup Instructions - Leadtek WinFast VP200 Schnellstartanleitung

Pcoip virtual desktop system
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 16
WARNING
1. Always power down and disconnect devices from AC power before handling them.
Failure to do this can result in personal injury or equipment damage. Some circuitry
on the host PC can continue to operate even though the front panel power switch is
off.
2. The Standalone Mode Power Connector on the host card must be disconnected
when the host card is operating in PCIe powered mode. Failure to do this can result
in damage to the host card.

Setup Instructions

PCoIP Virtual Desktop System (Portal + Host Card), follow steps 1 through 3.
Ÿ
PCoIP Desktop Portal only, follow step 1.
Ÿ
PCoIP PCIe Host Card only, follow step 2.
Ÿ
1 PCoIP Desktop Portal Installation
1. Be sure the monitor and the Portal are turned off and disconnected from AC power.
2. Use a DVI cable to connect the monitor to the Portal's DVI Port 1 (9).
3. Plug the monitor's power cable into an AC outlet and power it on.
4. If you are using dual monitors, repeat Steps 1 through 3 but connect the second
monitor to the Portal's DVI Port 2 (10).
5. Connect a USB keyboard and mouse to the Portal's rear USB ports (7).
6. Use an Ethernet cable to connect the Ethernet switch or router to the Portal's
Ethernet jack (8).
7. Connect the Portal power supply to the Portal's power jack (12), then plug the Portal
power supply into a surge-protected AC outlet.
8. Optionally connect the following devices to the Portal:
PC speaker to Speaker jack (11)
Headphones and MIC to Headphone (5) and Microphone jacks (6)
USB peripherals to auxiliary USB ports (4)
9. Power on the Portal by pushing the power button (2). The power button will light
steady green and the monitor will display the On Screen Display (OSD).
NOTE
If the monitor does not show the On Screen Display (OSD), check all connectors and be
sure the monitor and Power are powered on. Note the LED indicators:
Off: AC power is off
Solid yellow: AC power is on and Portal power is off
Solid green: Portal power is on
Blinking green: Host PC is in low-power states
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis