Declaration Of Conformity - B+BTec Diamond 250RS series Bedienungsanleitung

DIAMOND3
Water doesn't flow
at the blade but the
pump is running .
Motor isn't running
smoothly .
Pump isn't running .
Cutting out of
alignment .
DECLARATION OF
CONFORMITY
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization
documents .
EN-55014-1, EN-IEC- 61000-3-2:2014,
EN-IEC- 61000-6-2, EN-ISO 11204,
EN-ISO 3744, NEN-EN-ISO 12100,
EN-IEC 60204-1, ISO 5349-2 .
Conforms to the following standards or
normative documents 2006/42/EG,
2014/30/EU, 2014/35/EU .
Subject to change without notice .
250 RS SERIES
®
The sprayers are clogged .
The water level in the water bin
is not sufficient . The pump is not
totally submerged .
Water valve is closed .
Water may have seeped
through inside the motor .
Capacitor is damaged .
Damaged motor bearing .
The impeller or suction filter of
the pump is damaged .
No proper connection of the
power cable .
Machine is not leveled out .
Unstable working surface .
Improper or glazed diamond
blade .
Clean the sprayers .
Fill the water bin with clean
water until the pump is totally
submerged .
Open the valve .
Unplug the power cable and
consult your local dealer .
Replace damaged parts .
Have the connection checked .
Loosen the screws for the legs .
Pick up the machine a little bit
on one end . Let the machine
down again and tighten screws .
Perform the same procedure
on the other end . The machine
should now be leveled out .
Make sure the machine is placed
on a leveled surface .
Replace or dress the diamond
blade .
R .G .W . van den Boogaart
General Manager
Zevenbergen, April 2016
For spare parts or advice contact
B+BTec
Munterij 8
4762 AH Zevenbergen
The Netherlands
+31 168 331 260
info@bbtectools .com
21
GB