Cleaning And Care - Mondial PREMIUM VIP CARE VP-02 Bedienungshandbuch Und Technischer Kundendienst

Put back the tank and then press the Button in the "I" position (on).
-
The steamer will be ready for use again in about 4-5 seconds.
-
˃ When you finish using the Steamer, press the Button in the "0" position (off) and
remove the Plug from the socket.
Completely empty the Water Tank before keeping the Steamer.
˃
For best results
The Steamer easily removes wrinkles from clothes, tapestry and other fabrics It can also be
used to sterilize and remove odors from clothes and fabrics without damaging them.
Before using the product, check to see if the indicated voltage is the same as your local
mains voltage. Do not forget to follow the SAFETY TIPS.
1. Assemble your Steamer following the instructions.
Place it on a flat, firm and leveled surface.
2.
Check to see if there is water in the Tank for the operation.
3.
4. Place the piece of cloth you wish to press on the Hanger and make sure it is well
extended. You can also use another hanger by fixing it on the adjustable Pole.
5. Make sure the Steamer has the On/Off button in the "0" position (off) and then
connect the Plug of the appliance in the power socket.
Hang the Steam Nozzle on the Support located at the top of the Pole and press the
6.
On/Off Button in the "I" position (on). In about 45 seconds steam will start to flow out
and the appliance can be used.
Direct the Steam Nozzle to delicately press your clothes.
7.
Start pressing vertically, from bottom to top, along the inside and outside of the
8.
fabric, removing the wrinkles. DO NOT allow the Hose to fold at any point in time.
9. Direct the Nozzle away from the cloth and smoothen out the fabric with your free
hand.
Repeat the procedures described in items 8 and 9 until the fabric is wrinkle-free.
10.
11. Curtains and draperies can be steamed in the hanging position.
12. To remove wrinkles from towels, handkerchiefs and napkins, hang them on a
clothes line or fence and gently steam them.
Heavier fabrics may demand various repetitions of the process.
13.
14. To remove persistent wrinkles, steam both sides of the fabric.
15. The brushes supplied with the product can also be used to facilitate the removal of
difficult wrinkles.
NOTE:The Steamer can be used to press any type of fabric except LINEN.
Care should be taken to prevent the steam outlets from staying too long on the same
spot on the more sensitive fabrics.
NOTE:
When the Nozzle is not being used, place it on the Support at the top of the Pole to
˃
keep the steam from burning or damaging surfaces.
˃ The steam outlets can cause burns.
˃ Use the appliance with the Nozzle always positioned over the Body of the product.
Do not leave the Steam Nozzle on the floor with the appliance running.
˃
Do not aim the steam at persons, animals, appliances or power sockets.
˃
˃ To avoid overheating of the appliance, frequently check the water level of the tank.
CAUTION:
Be cautious when handling pieces of clothes on the Steamer Support. If the piece of
˃
cloth is pulled too strongly, it make cause the appliance to tumble.
16 UK

CLEANING AND CARE

˃ Remove the Plug from the socket before you start cleaning.
˃ Let the Steamer cool for at least 30 minutes.
Clean the outer part with a soft and dry cloth or slightly damp in order not to damage
˃
the surface finish.
˃ Do not use abrasive products, sponges or other types of cleaning accessories to
prevent damaging the finish of the appliance.
Do not use solvent or any type of chemical substance during internal or external
˃
cleaning and do not allow the moisture to penetrate the base.
˃ Wash the accessories with water and neutral detergent. Dry them well with a soft
cloth or paper towel. Do not use abrasive sponges in order not to damage the
surfaces.
Remove the Hose and retractable pole.
˃
˃ Remove the Tank and empty it. Rinse the Tank in running water and dry it. Place
the Tank back in the Steamer.
Do not keep the accessories or components damp or wet because it can damage
˃
them.
˃ Repeat the operation whenever the Steamer has not been used for a long period of
time.
Keep your MONDIAL VIP PREMIUM STEAMER in a flat, dry and safe place away
˃
from the reach of children.
Removal of mineral residue build-up
One common problem with Steamers is the build up of mineral residues in water. The
mineral residue can cause intermittent steaming or, in some cases, no steam formation.
To reduce the build up of mineral residues, we recommend following the procedures below
every month:
1. Turn off the appliance and disconnect from the socket.
Wait for the Steamer to cool down completely.
2.
Remove the Hose and Pole from the appliance.
3.
4. Remove all the accessories from the product.
5. Drain the Water Tank.
Prepare a solution of 50% vinegar and 50% water. In most cases, two cups of this
6.
solution is sufficient.
7. One solution with two cups of clean water and three spoons of Bleach can also be
used.
Connect the Plug to the socket.
8.
Press the On/Off button in the "I" position (on) and allow the steam to flow out until
9.
all the water from the Tank has dried up.
10. Turn it off again and remove the Plug from the socket.
Repeat the cleaning of the Tank to eliminate any residue or smell from the solution
11.
used.
12. Reassemble the Steamer and use normally.
Storage
When not in use, the Steamer should be stored correctly, according to the instructions
UK 17