Operating The Remote Control; Menu-Functions; End Point Adjustment (Epa) - Gm-Racing Xg-6I Bedienungsanleitung

OPERATING THE REMOTE CONTROL

• Run your car never with low transmitter or receiver batteries.
• If the low battery alarm on the transmitter, stop running your model and change or
recharge batteries!
• Never forget switch off the radio after running your vehicle , otherwise the batteries do
not last long.
• Turn on the transmitter fi rst, then the vehicle.
• After driving fi rst turn off the vehicle, then the transmitter.
• For optimal use fi rst check the steering and throttle trim positions.
MENU-FUNCTION

1. END POINT ADJUSTMENT (EPA)

Use this when performing left and right steering angle adjustments, throttle high side/
brake side operation amount adjustment, and channel 3 servo up side/down side operati-
on amount adjustment during linkage. EPA adjusting value range: 0~120 %, default is
100%
1. Press "ENTER" in the power on interface and enter function menu. Press "+" or
"-" to choose "EPA". And press "ENTER" and enter EPA adjusting interface.
2. Press "ENTER" to choose each adjusting item, and then press "+" to increase and
"-" to decrease the value of the corresponding item.
3. Press "EXIT" to save your setting and leave EPA interface, and back to the function
menu interface.
TERMS:
F-FORWARD,B-BACK,ST-STEERING, TH-THROTTLE,AUX-AUXILLIARY
03 94001 GM-Racing XG-6i Race Spec Instructions
94001-eng.indd Druckbogen 4 von 10 - Seiten (4, 17) 94001-eng.indd Druckbogen 4 von 10 - Seiten (4, 17)
Main menu
Submenu
94001 GM-Racing XG-6i Race Spec Instructions 16
19.01.2009 08:02:46 19.01.2009 08:02:46