Technical Data; Safety Instructions; Package Checklist - Thinknx Micro Inbetriebnahmeanleitung

Technical data

Power supply
Power consumption
Operating temperature
Rated surge voltage
Protection class
Type of protection
Device measurements
Package measurements
Weight
Compliances

Package checklist

- Micro / Micro Z-Wave / Brickbox
- BUS terminal connector
- Power Adapter
- Installation Sheet
- USB Z-Wave Transceiver (Micro
Z-Wave only)
First configuration
The first configuration of the server is via web console. To reach web console, an internet
browser must be used (Firefox or Chrome is recommended). Please write the following address
into browser: http://<ip address>:5051
following credentials:
User: service
Password: password
To find the IP address of the server, a search utility is available and can be downloaded from:
www.thinknx.com. The server is configured to use DHCP. If DHCP fails, the server will acquire
the following address by default:
always reachable at the address:
To restore the factory settings, press the RESET button at the bottom of the device for at least 10
seconds and wait until the «KNX activity LED indicator» ( ) stops blinking.
12-24 VDC - 1A Max
4 Watt
0°C / +50°C
4 kV
III
IP20
106.5 x 93 x 29 mm
145 x 130 x 110 mm
400 gr.
CE Directives
where «ip address» is the server one. At first login use
192.168.0.200.
192.168.24.254

Safety instructions

ThinKnx Micro server must be installed in
compliance with electrical installation rules of
your country. The server must be installed in
a dust free place, not subject to water
infiltration and must not be placed near a
source of heat or in direct contact with the
sun.
To reduce the risk of electric shock,
this product should
by an authorized technician when
service is required.
Disclaimer
Not attending to these safety instructions
might cause fatal accidents, injuries and
damages to persons and properties.
The manufacturer / supplier assumes no
liability for damages caused by failure to
comply with the intended use.
If a static IP address has been set, the server is
(with subnet mask 255.255.255.252).
only be opened