RIDGID 88752 Montageanleitung Seite 3

Instructions
(figure 1)
1. Unbolt the Padlock Tab, which is fitted inside the Lock Box.
2. Slide the Padlock Tab over the padlock's hasp, using the round hole. Close the padlock.
3. Slide Padlock Tab Assembly into the Lock Box.
4. Fix the Padlock Tab to the top hole of the Lock Box.
NOTE: PADLOCK CHOICE
Although many padlocks will fit, correct fit is important. Once the proper lock is installed, it cannot be removed without
dismantling the system. To be sure you have proper padlocks, measure it in the closed position and verify the dimensions seen
in figure 2.
Bolt
Padlock Tab inside Lock System Housing
!
STORAGE
This product is intended and safe for storing and transporting small tools and other non-combustible, non-flammable
materials. DO NOT use this product for storing or transporting flammables, explosives, hazardous materials or waste,
such as gasoline, solvents, gun powder, dynamite, gases or any tanks, torches or gas powered equipment.
!
TRANSPORT
Product must be secured to the vehicle when transported. Cover and doors must be locked when transporting in open
vehicles. Wind and bumps could create a condition where the product could open, causing it to tip over or out of the
vehicle causing serious personal injury and property damage.
!
WARNING
Keep hands clear when closing lid to prevent serious personal injury.
PADLOCK INSTALLATION INSTRUCTIONS
Padlock tab
Use top hole
on lock box
Use round hole for
padlock
Lock box
Figure 1
Locking nut
Padlock Dimensions
Open: Min. 1 7/16" (37mm)
Closed: Max. 1 3/16" (30 mm)
Figure 2