Inserting/Changing The Battery - Powerfix Profi PDM 300 A1 Bedienungsanleitung Und Serviceinformationen

Inserting/changing the battery

The multimeter is powered by a 9V battery. To insert or replace the battery, proceed as follows:
Switch off the multimeter and remove all test leads before opening the multimeter!
If the battery is exhausted, the
replaced as soon as possible to ensure that the multimeter continues to work properly.
 Remove the holster [2].
 Remove the two screws on the back of the multimeter and remove the back panel.
 Connect the 9V battery with the correct polarity (note + and –) to the battery clip and place
the 9V battery in the battery compartment.
 Replace the back panel and screw it tight with the two screws.
 Re-insert the multimeter in the holster [2].
icon appears on the display [1]. The battery should be
POWERFIX PDM 300 A1
English - 61