Doperation; Ecleaning & Maintenance - CombiSteel 7465.0020 Gebrauchsanweisung

*Control Panel;
*Operating;
Before operating the appliance, clean the blade and tank with wet cloth and dry.
Provide the ducts on cutting blades to pass on to the shaft.
After loading the materials into the tank ,put the lid on the tank.
Press START button to operate the appliance.
If it is wanted to add material without opening the lid while the appliance is working, solid materials can be
added through lid space after dividing into small pieces.
Press STOP button to turn off the appliance.
After the operation completed, unplug the power supply.

CLEANING AND MAINTENANCE AFTER EVERY USE
Clean outer surface of appliance, tank and cutting blade with hot water and then dry.
Always turn off the appliance and disconnect from the power supply before cleaning.
Do not use abrasive cleaning chemicals as these can leave harmful residues.
Do not clean the appliance by spraying water directly, otherwise electric motor may get damaged.

PERIODIC CLEANING AND MAINTENANCE
Maintenance should be done by qualified person.
Get the periodic maintenance of the appliance once in every 15 days.
The Cutter Mixer requires low maintenance (Motor and ball bearings are lubricated ). Maintenance of
appliance's contactor should be done by compressed air according to frequency of use.
Maintenance of cutting blade ;
Grind the blade with aqueous grinding wheels without disrupting blade angle.
D OPERATION
E CLEANING & MAINTENANCE
A : OFF/ STOP BUTTON
B : ON/ START BUTTON
5