Troubleshooting - GGP ITALY SPA SV150 Gebrauchsanweisung

6.7
ADJUSTMENT OF THE ACCELERATOR
CABLE
If the engine does not reach its maximum rpm
with the throttle control in "FAST" position, this is
likely due to an out-of-phase connection
between the accelerator lever and the governor
lever.
To restore the correct phase:
a) Stop the engine, remove the spark plug cap

7. TROUBLESHOOTING

PROBLEM
a) Hard starting
b) Inconsistent
working
c) Loss of power
while mowing
LIKELY CAUSE
- No fuel
- Stale fuel or build-ups in tank
- Spark plug disconnected
- Dirty electrodes or incorrect gap
- Air filter clogged
- Incorrect oil for the season
- Fuel evaporation in the carburetor
(vapor lock) due to high temperatures
- Fault in carburation
- Hard starting
- Stale fuel or build-ups in tank
- Dirty electrodes or incorrect gap
- Air filter clogged
- Fault in carburation
- Hard starting
- Air filter clogged
- Fault in carburation
- Governor out of phase with respect
to the accelerator
and wait until the engine has cooled.
b) Loosen the screw (1) of the clamp (2) so that
the cable casing (3) is free to move.
c) Move the throttle control to "SLOW".
d) Move governor control lever (4) forward as far
as possible and, by keeping it in this position,
lock the casing (3) full tightening the screw (1)
of the clamp (2).
SOLUTION
- Check and top up (see 5.1.3)
- Empty fuel tank and refill with fresh
fuel
- Check that the spark plug cap fits
well over the plug terminals (see
5.1.4)
- Check (see 6.6)
- Check and clean (see 6.5)
- Replace with proper oil (see 6.3)
- Wait for a few minutes then start
again (see 5.3)
- Contact a Licensed Service Centre
- Contact a Licensed Service Centre
- Empty fuel tank and refill with fresh
fuel (see 6.8)
- Check (see 6.6)
- Check and clean (see 6.5)
- Contact a Licensed Service Centre
- Contact a Licensed Service Centre
- Check and clean (see 6.5)
- Contact a Licensed Service Centre
- Adjust the cable (see 6.7)
7
EN