Shure M367 Bedienungsanleitung

2 2 2 H A R T R E Y A V E
.
E V A N S T O N , I L L . ( 6 0 2 0 4 ) U.5 A.
MICROPHONES AND ELECTRONIC COMPONENTS
/
y, @d
L'
5)
fs
DATA SHEET
STEREO DYNETIC@
PHONOGRAPH CARTRIDGE
SPECIFICATIONS
1 AND M32 CARTRIDGE SERIES
N31 AND N32 STYLI SERIES
(~eitical,
Model
1
Diamond Stylus
,
5; 1
Horizontal Tracking
Number Re~lacement 5 cm/sec) cm per dynd) (Grams)
Side Contact
Radius :
.0004" (.010 mm)
Frontal Radius:
*
The N32-3 stylus may be used t o reproduce the standard 78
rpm records. In this case, the amplifler should be set to "Mon-
aural" or "A-kB."
1 to 2
M31E
FREQUENCY RESPONSE:
From 20 to 18,500 Hz (M31E)
From 20 to 17,500 Hz (M32E)
C H A N N E L SEPARATION:
More than 20 d b a t 1,000 Hz
RECOMMENDED L O A D I M P E D A N C E
: 47.000 ohms per channel
N3lE Elliptical
Side Contact
Radius
:
.0002° (.005 mm)
Frontal R a d ~ u s
:
.0007" (.018 mm)
INDUCTANCE:
720 millihenries
D.C. RESISTANCE:
630 ohms
M O U N T I N G :
Standard
35"
(12.7 mm) mounting center
W E I G H T :
6 grams
T E R M I N A L S :
4 terminals
10.5millivolts
G E N E R A L :
The M31 and M32 Series of Dynetic phonograph
cartridges have been developed for use with all high fldelity am-
pliflers having magnetic and constant velocity inputs.
O P E R A T I ON
:
Recommended needle forces for optimum results
are listed under "Speciflcations." Forces greater than the indf-
cated "maximum" should not be used.
Yellow
CONNECTIONS
15.0 x 10-6
4 - L E A D STEREO CONNECTION:
Connect "hot" lead of right
channel to terminal "R" and shield or ground lead of right chan-
nel to terminal "RG."' Connect "hot" lead of left channel to ter-
minal
"L"
and shield or ground lead of left channel t o "LG."
To prevent "ground loops" and hum, no common connection
should be used a t cartridge terminals.
M O N A U R A L CONNECT I O N
: For single channel reproduction of
Monaural or Stereo record~ngs, connect "hot" lead to both " R
and "L" terminals and connect ground or shield lead t o both
ground terminals marked "RG" and "LG."
C A U T I O N :
Do not make solder connections to cartridge terminals.
Make all solder
connections
to terminal jacks provided before s l i ~ -
ping them over the terminals.