Specifications - EWT RB2M Bedienungsanleitung

SPECIFICATIONS

Model
Part number
Power
Speaker power
Remote control
Oscillation
Timer
Handle
Overheating protection
Frost protection
Anti-tilt protection
Voltage
Frequency
Product dimensions (LxDxH)
Product weight
INSTRUCTIONS FOR USE
BEFORE USING APPLIANCE FOR THE FIRST TIME
1. Please read these instructions carefully before using the
appliance and keep them for future use.
2. Check that the voltage of your local electricity network
complies with the one which appears on the appliance.
3. Before using the appliance for the first time, remove the
appliance's protective films or stickers.
4. Please check that switches on the side are on OFF
position.
When the appliance is plugged in, press the button (7) to
switch it on.
The appliance will select 25°C as the default temperature.
The heater will then be in standby mode. Press the
button to switch it on and activate the touch function of the
other buttons on the control panel.
MODE CONTROL
When the appliance is switched on, the default operation
mode will be Fan mode.
Press the button to change the mode.
Press it once to switch to Heating mode on speed 1 (low
heating) and the screen will display
Press it twice to switch to Heating mode on speed 2 (high
heating) and the screen will display
Press it three times to return to Fan mode and the screen
will display .
6
RB2M.indd 6
ROBO 2000W MUSIC
RB2M
2000W
3W
Yes – with CR2025 battery
Yes
8H
Yes
Yes
Yes
Yes
220 - 240 V~
50 HZ
L24 x D24 x H64 cm
2.68 kg
.
UK DE
TIMER
Press the button to set the timer and programme when
the appliance should stop functioning. The timer can be set
for a period of up to 8 hours with 1-hour intervals.
When the timer is activated, the
on.
To stop the timer, press until the timer indicator reaches
0 hours.
OSCILLATION ON/OFF
The allows you to switch oscillation of the appliance on
or off. When oscillation is switched on, the
the LED display screen.
WIRELESS CONNECTION
This mode allows the appliance's speaker to be connected
to a smartphone or a tablet via wireless connection, allowing
you to listen to music or the radio.
Press the symbol on the control panel.
Select the name of the appliance "EWT RB2M" on your
smartphone or tablet.
Once the connection has been established, start and control
music or the radio on your smartphone or tablet.
REMOTE CONTROL
1. When inserting or removing the battery, please consult
the diagram below. Pay attention to the guide on the lid
explaining the positioning of the positive and negative
symbols on the battery.
2. Remove the protective cover from the battery slot of your
remote control and place the 3V CR2025 inside.
3. Avoid dropping the remote control or allowing it to fall to
the floor.
4. Batteries contain materials that are dangerous for the
FR IT NL PL
indicator light will switch
will be lit up on
A. Appliance On/Off
B. 8H Timer
C. Oscillation mode
D. Control of heating and
fan modes
E. Decrease
F. Increase
G. Wireless connection
control
11/06/19//24 13:57
envi
batt
disp
recy
CLEAN
Switch
the soc
• Clea
brus
• Do n
• Do n
spiri
• Neve
• Air in
clea
• If th
be p
RECYC
exist. C
advice
Batteri
with W
recycle