Sulion Falcon Installationsanleitung Seite 26

mote control for 6 continuous seconds.
2. The fan light will flash and the fan will start rotating for
90 seconds in one direction. It will stop and automatically turn
90 seconds in the opposite direction. Do not press any key until
the process is complete.
3. Now, transmitter and receiver of the fan/s will have been
synchronized. Remove the power of the fan using the switch or
the breaker and then turn it on again, this step is the one that
EN
closes the synchronization process.
4. To synchronize another fan and remote control, you must
disconnect the power or turn off the wall switch (if not shared
with the new fan to be synchronized) of the fan already syn-
chronized and connect only the fan you want sync up.
Then repeat the points from 1 to 3.
Once the fan is synchronized if it is turned off from the switch, when
it is turned on again and a speed is pressed, the fan starts turning
90 seconds at the maximum speed to perform a start-up. After
that 90 seconds, the fan rotates at the selected speed. If the fan is
switched off from the remote control, you do not need to start up
for 90 seconds.
Remote control safety functions
Blocking protection
The remote receiver includes a function that automatically
blocks motor operation, cutting current to the motor 30 se-
conds after detecting an obstruction in front of the fan that
prevents normal operation. When this happens, you must re-
move the obstacles blocking the fan. Then, press the off button
on the remote control to reset the receiver. Now you can
continue to use the fan normally.
Note: Unless you remove the obstruction blocking the fan, it
will not operate correctly.
Overload prtection
If the fan's receiver detects that the motor is operating at
greater than 80W (this indicates an overload), current to the
motor will be cut automatically, which will immediately stop
the fan. To reset the receiver, press the off button on the re-
mote control.
26