Power Craft 629153 Gebrauchsanweisung Seite 29

Insert the awning unit (10) into the brackets.
Tighten the awning securely in the brackets
with the holders (C) and bolts (D). Tighten
the lock nuts on the brackets.
Use a spirit level to check that the awning
is straight. If this is not the case, loosen
the lock nuts on the wall brackets, turn
the adjustment screw until the awning is
straight and re-tighten the lock nuts.
You can change the angle of the awning in
relation to the wall in the same way.
Check that the awning is securely mounted.
Connect the awning cord (9) to a suitable
power outlet.
C
D
Use
Press the DOWN (18) or UP (16) buttons on
the remote control (14) to unroll or roll up
the awning. Press the STOP button (17) to
stop the awning moving.
You can adjust the outer positions of the
awning by turning the buttons (E, F) using
the adjustment tool (13).
E
F
The white button (E) determines the rolled
up position for the awning.
The red button (F) determines the unrolled
position for the awning.
If the awning is not connected to power,
you can also operate it manually: Insert the
hand crank in the eye by the interchange.
Turn the hand crank to unroll or roll up the
awning.
Once the front cross bar touches the case,
do not try to roll the awning in any further!
DK
NO
SE
FI
GB
DE
PL
ES
29