Power Craft 629153 Gebrauchsanweisung Seite 28

Mounting
Three people are required to mount the
awning.
The awning should form an angle of about
80 degrees in relation to the wall when it is
extended. The mounting height (C) should
be calculated as the desired height of the
outermost point of the awning (A) plus 0.17
× the awning's drop (here 0.17×250 cm =
43 cm).
GB
If instead you want an angle of 60° in
relation to the wall, replace the constant of
0.17 in the calculation with 0.50 to get the
mounting height.
If instead you want an angle of maximum
45° in relation to the wall, replace the
constant of 0.17 in the calculation with 0.71
to get the mounting height.
The lowest point of the awning should be
at least 250 cm from the fl oor when it is
unrolled.
There must be a clear space of 10 cm above
and 60 cm on each side of the awning once
it is fi tted.
28
C = A + 0.17 × H
Unroll the template (11) and place it
horizontally on the wall where the awning
will go.
Drill holes into the wall for the wall brackets.
The holes must be 12 mm in diameter and
100 mm deep.
Insert the expansion bolts (15) into the
holes on the wall brackets (8) and press the
expansion bolts into the drilled holes.
Check that all brackets are in a horizontal
line in relation to each other.
Tighten the brackets by tightening the
expansion bolts with a spanner.
Unscrew the holders (C) and bolts from the
brackets. Loosen the adjustment screws
(A) on the brackets using an Allen key (B)
and pull the support plate out so that the
distance to the bracket is at least 40 mm.
At a distance of 45 mm, the angle of the
awning to the wall will be 80°.
A
Note! The support plates must be lined up
on all the brackets.
B
C