Stop; Advice For Operation; Dry And Normal Snow; After Operation - GreenWorks 2600007 Gebrauchsanweisung

6.4 STOP

To stop the machine, release
the starter lever 8.B).
IMPORTANT If you have to leave
the machine, remove the battery.

6.5 ADVICE FOR OPERATION

Snow is removed more easily when it
is still fresh. Pass back over the already
cleared zones to remove snow residue.
If possible, clear the snow in the direction
of the wind. Check the distance and the
direction of the removed snow jet.
In strong winds, lower the
direct the discharged snow towards the
ground, reducing the likelihood of the wind
transporting the snow to the wrong areas.
Once you have
machine running for a few minutes to prevent
ice from forming in the discharge chute.

6.5.1 Dry and normal snow

Snow up to 20 cm can be quickly removed
by proceeding to evenly clear it away. For
deeper or built up snow, reduce the speed
and let the machine work at its own rhythm.
6.5.2 Wet or compact snow
Slowly move forward. Avoid using the lower
blade to remove compact snow and ice.
IMPORTANT Heavy use of the machine
with wet or compact snow can cause
faults to the auger compartment.

6.6 AFTER OPERATION

Immediately remove the battery
from its compartment.
Clean the remaining snow on the
machine with a brush (par. 7.2).
Move all the controls forward
and back a few times.
Tighten any nuts and bolts that are
loosened during operation.
Check there are no loose or damaged
components. If necessary, replace
the damaged components.
Do not cover the machine
when the motor is still warm.
to
work, leave the
EN - 9