Balluff BOS 21M-PA-LE10-S4 Kurzanleitung Seite 4

Setting
1. Position the emitter and receiver opposite each other at
the desired distance.
2. Turn the sensitivity potentiometer to maximum (greatest
range).
3. Determine the on- and off switching point of the output
(yellow LED): move the emitter or receiver so that the
yellow LED turns on and off again.
4. Install the moved sensor in the middle of the two
determined switch points. The system will function
optimally when the green LED is on and the yellow LED
off.
In order to detect very small targets, reduce sensitivity
and thereby the range, and space the two sensors
accordingly (see Step 3).
Technical Data
Optical data
Operating distance (typical
values):
Operating mode emitter
type ..-S4
Operating mode emitter
type ..-S4S
Emission type:
Electrical data
Power supply U
B
Ripple
Current consumption
(output current excluded)
Outputs depending on type
Switching function type ..-S4
Switching function type ..-S4S
Output current
Output saturation voltage
Switching frequency
Adjustment
Protection class
Mechanical data
Connections
Housing
Active surface material
Vibration
Shock
Dimensions
Weight
Time data
On delay
Display
Power ON (transmitter)
Stability (receiver)
Output (receiver)
0...60 m
light on Pin 2
dark on Pin 4
light on Pin 4
dark on Pin 2
Red Laser 650 nm
10...30 V DC
2 Vpp max.
35 mA max.
PNP or NPN
NC Pin 2
NO Pin 4
NC Pin 4
NO Pin 2
100 mA max.
≤ 2 V
1.5 kHz
Potentiometer
2
M12, 4 pole connector
GD-Zn, nickel plated
PMMA
55 Hz, 1 mm amplitude
30 g, 11 ms
50 x 42.5 x 15 mm
80 g.
333 µs
green LED
green LED
yellow LED
Ambient data
Mechanical protection
Ambient light rejection
Operating temperature
Storage temperature
Approvals
Listed 81U2 IND.CONT.EQ for
use in the secondary of a class
2 source of supply
IP67 (TYPE 1
ENCLOSURE)
according to
EN 60947-5-2
-10 ... 50 °C
non condensating
-25 ... 70 °C
Balluff GmbH
Schurwaldstrasse 9
73765 Neuhausen a.d.F.
Germany
Phone +49 (0) 71 58/1 73-0
Fax +49 (0) 71 58/50 10
E-Mail: balluff@balluff.de
www.balluff.com
4