Installation; Operation; Wiring Diagrams; Maintenance/Cleaning - Vortice VORTDRY 1000 series Betriebsanleitung

996 - Vort Dry 1000_Layout 1 04/05/2018 09:12 Pagina 9
ENGLISH

Installation

The appliance must be installed by a professionally
qualified technician using rawl plugs and bolts to fit it
to the wall.
This dryer must be installed out of reach of persons
using the bath, the shower, or the washbasin and in
accordance with all laws and standards governing
installation in the country where the appliance is
being installed.
The appliance should not be installed less than 150
cm off the ground.
÷
(Fig. 1 9).

Operation

The appliance starts working automatically once the
nozzle is removed from its holder (fig. 12) and
switches itself off when the nozzle is replaced (fig.
13). The dryer also switches itself off after about 20
minutes of uninterrupted use: in this case, to restore
normal operation, hook the device onto the wall
mount and wait for a few seconds.
VORTDRY 1000 PLUS: A transformer provides
power to two shaver sockets (230V and 115V) on the
dryer front housing (fig. 14)

Wiring Diagrams

(Fig. 15)

Maintenance/Cleaning

This appliance does not normally require any special
maintenance. As and when necessary, simply wipe off
dust with a soft, dry cloth. If necessary, use a cloth dam-
pened with luke-warm water and a neutral, non-abra-
sive detergent to remove more stubborn dirt. Check that
the air intake is not blocked by hair or fluff.
9