Working With The Movexx; Charging - Movexx T2500-Platform Anleitung

4. INSTRUCTIONS
f. Working with the Movexx
Attach/Link up...
Stand on the platform of the Movexx facing the machine. Drive backwards to the trolley to be
hooked up and couple the hook to the trolley (differs depending upon type of trolley)
Always mount hooks and base moduls with LocTite
Driving with the Movexx ...
Before operating the Movexx consult the conditions in chapter 4c and 4d once more concern-
ing people, obstacles, etc. When operating the Movexx from point A to point B the operator
should take the following position;
Stand on the platform of the Movexx facing away from the trolley. This is the pull-position. Al-
ways stand on the platform first so that the Movexx and/or the trolley cannot collide with you.
The Movexx may be moved both over level surfaces and up or down a slope in this position.
(Fig. 7 + 8)
Fig.7
g. Charging
When the battery indicator on the machine is flashing orange you must charge the batteries.
(Green is full, Red is completely empty) To charge the Movexx, position it next to a 110V/220V
wall socket. Turn the Movexx off. Plug the charger into the wall socket. Then charge according
to the instructions in the charger manual (until the battery indicator is green). When the batte-
ry is fully charged, follow these instructions in the reverse order. The Movexx is now ready for
use once again.
datasheet Movexx T1000
manual MovexxT2500- T3500-Platform
Manual T2500- T3500-Platform
Fig.7
EN
12