Reset The Dt2000; Configure The Dt2000 With Windows® Os - Kingston Technology DataTraveler 2000 Benutzerhandbuch

Reset the DT2000

If you forget the User PIN or want to delete all data stored on the DT2000, follow the instructions below.
The reset process will clear all cryptographic parameters, including the User PIN. This means that the DT2000
will revert to the default User PIN of 11223344. Refer to
Also, since this will force the creation of a new encryption key, the DT2000 will have to be reformatted. Refer to
Configure the DT2000 with Windows OS
Caution: Resetting the DT2000 will delete ALL DATA stored on the drive.
Instructions
1. Press and hold down the number 7
(pqrs) button and then press the
KEY button. Release buttons (7
& )
2. Within 10 seconds, press the
number 9 (wxyz) button three times
(triple-click) (999)
3. Press and hold down number 7
(pqrs) button and then Press the
KEY button. Release buttons (7
& )
Configure the DT2000 with Windows® OS
If hacking detection has been triggered by entering the incorrect PIN 10 times in succession, or the drive has
been reset, all data on the drive will be lost
Once a new User PIN has been created, the DT2000 will need to be initialized and formatted.
To initialize your DT2000, do the following:
1.
Create a new User PIN (Refer to
2.
Unlock the DT2000 by entering the new User PIN and connect it to a computer's USB port.
3.
The computer should display the following message:
Document No. 480ADT2000.B00
or Mac OS
LED
forever.
Change the User
Change the User PIN
for the corresponding process.
LED Status
Red and Green LEDs blink alternately
Red and Green LEDs continue to blink
alternately
Red LED fades out to complete the reset
process
PIN).
DT2000
for more information.
Page 25 of 30