Power; Setting The Time; Setting The Alarm; Snooze - THOMSON CR400iBT Bedienungsanleitung

*Note: When the phone is being charged your phone's charging indicator will show as normal.
*Note: For maximum charging efficiency, the phone must be aligned with the center of the charging
area.
*Note: Phones that are capable of wireless charging may need to be placed slightly off center. The
built-in wireless receiver may not be centered inside the phone. This varies by brand/model.
Note: Wireless Charging and Radio cannot be used at the same time.

Power

CAUTION
• Risk of product damager! Make sure that the power voltage
corresponds to the voltage printed on the back label.
• Risk of electric shock! When you unplug the AC power cord
always pull the plug from the socket. Never pull the cord.
• Before connecting the AC power cord, ensure you have completed
all other connections.
Place the unit in the desired position and unravel the mains cable. Insert the cable into the supply
socket and switch on if applicable.
Auto standby
When no music play from a connected device, the product automatically switches to standby if:
• No button is pressed for 10 minutes,
• No audio from a connected device for 10 minutes.

Setting the time

1. Short press TIME to make the hour blink.
2. Set the hour by pressing – or +.
3. Short press TIME again to make the minute blink.
4. Set the minute by pressing – or +.
5. Short press TIME or wait 15 seconds to show the current time.
6. Long press TIME to set up 12/24H mode.

Setting the alarm

1. Short press the ALARM button once to make the hour blink.
2. Press the – or + buttons as needed until the desired alarm hour is shown on the display.
3. Short press ALARM again to make the minute blink.
4. Set the minute by pressing – or +.
5. Press the ALARM button to save the time and select the BUZZER/RADIO.
NB: If you select RADIO, you will be awoken by the last preset radio at the last preset volume.
6. Short press ALARM or wait 15 seconds to exit alarm set up and return to the current time.

Snooze

1. Press the SNOOZE button to snooze for 9 minutes.
2. When the alarm sounds, press ALARM to cancel snooze.

Dimmer control

1. Press the dimmer (SNOOZE button) to control the brightness of the digits on the display.
2. There are 3 levels: High (bright)
Turning the alarm on/off
1. Long press ALARM, the alarm icon will display.
2. Long press ALARM again, the alarm icon will disappear.
Medium (dim) Low (off)
- EN 4 -