Connecting A Peripheral Usb Device - Sony UPA-PC700 Installationsanleitung

4
Close the rear cover.
For details, see "To close the rear cover" on page 7.
Connecting a Peripheral
USB Device
Follow the procedure below to connect a peripheral USB
device to one of the designated USB ports inside the unit.
For details on connecting a specific device, refer to the
manual that came with the device.
Supported USB devices
The following peripheral USB devices can be connected to
the internal USB ports on the UPA-PC700:
• UP-D75 (Sony Digital Photo Printer)
• UP-DR200 (Sony Digital Photo Printer)
• UP-GR700 (Sony Digital Photo Printer)
Notes
• To avoid causing a fire or damaging the unit, never
attempt to connect an unsupported device. For more
details about the types of devices supported by the unit,
consult your dealer.
• Up to three UP-DR200 printers can be connected to the
UPA-PC700.
• Up to one UP-D75 or UP-GR700 printer can be
connected to the UPA-PC700.
To connect a USB device
1
Open the rear cover.
For details, see "To open the rear cover" on page 7.
2
Connect one end of the USB cable to one of the four
designated USB ports inside the unit.
Notes
• The six designated USB ports for connecting
peripheral USB devices are shown by 3 under
"Internal Connectors" on page 8.
• When wiring and bundling cables, leave some slack
inside the cabinet to prevent a sudden pull on the
cable from disconnecting the cable or damaging the
connector.
3
Connect the other end of the USB cable to a USB port
on the device.
4
Close the rear cover.
For details, see "To close the rear cover" on page 7.
5
Turn on the peripheral USB device.
Notes
• Connect peripheral USB devices directly to the USB
ports on the unit. Operation through a USB hub is not
guaranteed.
• If a message prompting you to install drivers appears
when you connect supported peripheral devices to the
unit, contact your dealer.
• When the UP-DR200/UP-D75/UP-GR700 is connected
to the UPA-PC700 and powered on, the following dialog
appears:
"A change of device connection has been recognized.
Please wait for a while.", and "The connection has been
made in the system."
Do not operate the system while the dialog is displayed.
9
Connections