Inhaltsverzeichnis
Werbung
I
NSTALLING THE
2. Set the device on a flat surface near an external power source, making
sure there are at least two inches of space on all sides for proper air
flow.
3. If installing a single switch only, go to Grounding the Chassis at the
end of this chapter.
4. If installing multiple switches, attach four adhesive feet to each one.
Place each device squarely on top of the one below, in any order.
3-6
S
WITCH
Figure 3-4 Attaching the Adhesive Feet
Werbung
Inhaltsverzeichnis
