Initial Setup; Setting Up The Rock Master - THINK GIZMOS TG631 ROCK MASTER Bedienungsanleitung

2. INITIAL SETUP

2.1 Setting up the Rock Master

● Ensure the truck is switched off.
Locate the battery compartment on the
●
underside of the truck.
Using a small Philips screw driver unscrew
●
the single screw for the compartment.
Remove the battery cover and insert the
●
batteries in the correct polarity shown in
the compartment.
Re-fit the battery cover and secure with
●
the screw.
Switch the power on the underside of the
●
Truck to the "ON" position.
You are now ready to begin driving.
●
4
Find the cover on the bottom of the
●
controller.
Using a small Philips screw driver unscrew
●
the single screw for the compartment.
Remove the battery cover and insert the
●
batteries in the correct polarity shown in
the compartment.
Re-fit the battery cover and secure with the
●
screw.
Turn the switch to the "on" position.
●
The red indicator light will illuminate when
●
the trigger is pressed.
The Rock Master is controlled via a 2.4ghz controller.
This means there is no need to worry about other
cars and the frequencies they are on as this truck
will always find an unused channel. Unlimited Rock
Crawlers can be controlled at the same time without
interference from each other.
If you buy multiple rock crawlers all your friends can
play with theirs at the same time!