Beper VE.112 Betriebsanleitung Seite 13

Stand Fan Use instructions
The mode indicator is green.
Sleep: In this mode the fan simulates a soft, natural breeze suitable for night-time use. The indicator
is off.
WING
• Press the SWING button (on the remote control or on the control panel) to activate the oscillation
function for widespread breeze distribution.
• Press the button again to stop oscillation when the fan head is in the desired position.
TIMER
Push the "timer" button (when the fan is working) to set the timer for the fan's shut off: the led light
corresponding to the time set will appear. You can set the fan timer to a maximum of 7,5 hours. You
can set the time half hour by half hour by pushing the Timer button on the remote control or on the
control panel.
Tilting the fan head:
The fan head can be tilted so that the breeze is targeted at an angle.
• To tilt the fan head, make sure the fan is disconnected from the power supply.
• Steady the motor housing of the fan with one hand, grip the fan head with the other and carefully
tilt the fan head until it reaches the desired angle.
CAUTION: Do not tilt back the fan head further than it is intended to go.
Doing so will damage the unit.
Components: Fig.2
1. Front and rear grilles
2. Motor
3. Fan blade
4. Control panel
5. Extension pole
6. Height adjustment ring
7. Base tube
8. Remote control
9. Base
Control panel:
10 Swing indicator
11 Mode indicators:
Sleep, Nature, Normal
(default, no indicator)
12 Fan speed indicators:
High, Mid, Low
13 Timer indicators:
0.5H, 1H, 2H, 4H,7.5H
14 OFF button
15 ON/SPEED button
16 TIMER button
17 SWING button
Remote control buttons:
18 MODE button
19 TIMER button
20 ON/SPEED button
21 OFF button
22 SWING button
23 LAMP button
13
EN