Cotech OTL-24-3-DIM-TI Bedienungsanleitung

LED Downlights
Art.no 36-5610 Model OTL-24-3-DIM-TI
36-5611 OTL-24-3-DIM-WH
Please read the entire instruction manual before using the product
and then save it for future reference. We cannot be held responsible
for any errors in the text or images or changes to technical data.
If you experience any technical problems or have any other questions,
please contact our Customer Services.
Safety
Note: You may mount the light fittings onto the ceiling yourself, and
connect them to the junction box. However, connection to the 230 V mains
power supply should only be carried out by a qualified electrician.
• Get a qualified electrician to perform the mounting and installation
work if you are at all unsure about carrying out the procedure
yourself.
• The power switch/dimmer must be connected to the primary
(230 V) side of the LED driver.
• Repairs should only be carried out by a qualified electrician.
• A minimum of three and a maximum of six light fittings may be
connected to the constant current transformer.
• The lights must be connected in series, use the junction box
supplied to ensure the correct connection.
Specifications
Protection class IP23
Constant current transformer 350 mA, max 20 W
Power LED 3 W (10.3 V)
Colour temperature 3000 K (warm white)
Luminous flux 220 lm
Hole diameter 63 mm
GREAT BRITAIN • CUSTOMER SERVICE tel. 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk
postal 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ
Mounting
Note: Ensure that the 230 V mains voltage is disconnected before
the work begins.
Note: A minimum of 3 and a maximum of 6 light fittings must
be connected.
The LED driver (constant current transformer) is either controlled by
a power switch or dimmer designed for electronic transformers (ET).
Flush mounting
1. Drill a hole in the ceiling (Ø 63 mm),
mounting depth 30 mm.
2. Lead cables and light fittings into the hole, ensure that the light
fittings are properly fixed and connect the cables to the junction box.
Note:
• The junction box has room for six light fittings. If only the three
supplied light fittings are connected, three of the jumpers provided
must be connected to the junction box in order for the light fittings
to function. If four light fittings are connected, two jumpers must be
connected. If five light fittings are connected, one jumper must be
connected.
• The light fittings are connected in series (see fig. to the right).
Surface mounting
1. The metal boxes supplied must be used with surface mounting.
Pull the flexible cable through the hole in the back of the box.
2. Ensure that the flexible cable is in the notch along the bottom
of the box and fix the metal box to the ceiling using the screws
provided.
3. Push the light fitting into the box and ensure that it is fixed properly.
Responsible disposal
This symbol indicates that this product should not be
disposed of with general household waste. This applies
throughout the entire EU. In order to prevent any
harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed
in for recycling so that the material can be disposed of
in a responsible manner. When recycling your product,
take it to your local collection facility or contact
the place of purchase. They will ensure that the product
is disposed of in an environmentally sound manner.