Neoline X-COP 8700s Kurzanleitung Seite 3

3. Installation on the dashboard
• Attach the magnetic mount onto a flat surface of the dashboard.
• Place X-COP 8700s into a magnetic mount.
• Fix the radar detector in a horizontal plane, since the police radar waves fall onto this
area.
• Connect X-COP 8700s to the car socket with the 12...24V power cable.
4. Installing sun visor
• Remove the cap from the sun visor connector.
• Take the sun visor out of the X-COP 8700s box and push it into the groove on the
front of the radar detector body with little effort.
5. Connecting Fuse Cord
• Connect the Fuse Cord power cable to the
connector on the right side of the device.
• Route the power cable to the fuse box.
• Connect the power cable to the fuse box in
accordance with the instructions:
- Connect the B power cable (+) to the circuit
providing stable 12V voltage.
- Connect the GND cable (-) to the vehicle
ground.
GND
+12V
B+
3
2A