Britton Alpha+ Gebrauchsanweisung Seite 5

FITTING THE TRAY
Slide the two bar ends (A) into the seat frame tubes (B) and push in the spring pips, continuing
to push the bar ends until the pips appear in the holes and you'll hear the 'click'. (Fig. 2)
FITTING THE SEAT COVER
Push the second lock (C) to open the frame. (Fig. 3).
Slide the curved part of the seat back bar into the fabric pocket on the seat.
Secure the seat cover sides by wrapping them around the frame and fasten press studs (A) on
both sides of the seat.
Fasten the strap buckle (B) under the seat.
OPENING THE CHAIR
Open the seat frame fully and press the tray firmly down. (Fig. 4)
Fasten the plastic buckle (A) to the tube.
FITTING THE LEGS
Please be noted that the front legs are wider at the top than rear leg.
Identify which leg is the rear and which is the front.
Remember that the front leg attaches to the back of the highchair (A) whilst the rear leg is
attached to the front (B). (Fig. 5)
Push a pair of the legs a little way into the seat frame tubes and push in the spring pips, con-
tinuing to push the legs until the pips appear in the holes. (Fig. 6)
Repeat this process until each leg is fitted securely.
Should the highchair need to be taken apart, gently push in the sprung pips with a small screw-
driver and evenly ease out the legs assemblies.
The fit of the legs in the frame is very tight for added security. Do not force the legs into posi-
tion, but apply an even and constant pressure.
HARNESS
Ensure the waist straps and crotch strap are fed through the slots in the seat unit. (Fig. 7)
Turn highchair upside down, wrap the split metal rings at the end of each harness around the
corresponding support bar and thread the webbing through the small gap in the metal ring (A)
so it is attached as you can see in B. (Fig. 8)
A five-point safety harness is provided to restrain your child and should always be worn.
Sliding adjusters (A) are fitted and should be carefully adjusted so the harness fits your child
comfortably. (Fig.9)
To fasten the harness push the side pieces into the centre buckle.
To release, press button in centre buckle (B) and remove the buckle.
FOOTREST
Push the footrest tubes into plastic shell of footrest, push in the spring pips and continue to
push until the pips appear in the holes. (Fig. 10)
FOLDING
Release the plastic buckle (A) and turn the tray to the back of the seat. Push the second lock
(B) and fold the legs together. (Fig. 11)
Importer: Speli Baltic Ltd, Estonia. Tel. +372 6700623; info@brittonbaby.com
EN EN
5